Kamis, 21 April 2011

Mengkonfigurasi Jumper pada Harddisk


A little knowledge is for the beginner in an IT or people who want to learn computers, about how to set a jumper on the disk. Set the jumpers on the hard drive is useful if you have two hard drives in a computer or have an ATA IDE cable in a computer which arranged for the computer to read the hard drive first, because the hard drive is a medium where we keep an Operating System if you have two hard drives and set jumpers on the second hard drive.


Two hard disk to be configured jumpernya, for the first disk is a disk in which an Operating System is going to be a master and for a second hard drive will be used as Slave.



See the picture above is a picture Configuration Jumper:

  • Master or Single drive is an option to make the hard drive as master or make the drive to read the first time by computer.
  • Drive is Slave is the option to make the hard drive as Slave, slave intent here as a second choice.
  • Master with non ATA-compatible slave is to make the hard drive as main drive is paired with with non-ATA drive as the slave.
  • Limit Dirve Capacity is Used when no message at start up, "Hard disc drive controller failure", Computers can not detect the new HD installed, or the system no response when installing a new drive

1 komentar:

ami bimatama mengatakan...

informasi bermanfaar gan,kembangkan lebih bagus ya ganhttps://goo.gl/mDmFZx

Posting Komentar

Twitter Delicious Facebook Digg Stumbleupon Favorites More

 
Design by Free WordPress Themes | Bloggerized by Lasantha - Premium Blogger Themes | coupon codes